WALL LINE INPUT - 45X45 MM- TERMINAL BLOCK - WHITE

WALL MIC INPUT - 45X45 MM- RJ45 - BLACK

WALL MIC INPUT - 45X45 MM- TERMINAL BLOCK - BLACK

Amplificateur classe D - 2x 270W sous 4 ohms

Le SLI300.2 est un amplificateur de classe D compact et puissant à faible impédance.
Il délivre 2 x 270 W sous 4 Ohm.
Il dispose d'un contrôle de volume et d'indicateurs LED pour le signal, le clip et la sécurité, pour un fonctionnement intuitif et sûr.
Les connexions se font via des fiches combo et Speakon, pour une grande polyvalence et une installation facile.
Le SLI300.2 est idéal pour les applications nécessitant une alimentation fiable et des performances audio de haute qualité.
Dimensions : 483 x 44 x 360 (mm) 1U 19 pouces

Amplificateur classe D - 2x 450W sous 4 ohms

Le SLI500.2 est un amplificateur de classe D compact et puissant à faible impédance.
Il délivre 2 x 450 W sous 4 Ohm.
Il dispose d'un contrôle de volume et d'indicateurs LED pour le signal, le clip et la sécurité, pour un fonctionnement intuitif et sûr.
Les connexions se font via des fiches combo et Speakon, pour une grande polyvalence et une installation facile.
Le SLI500.2 est idéal pour les applications nécessitant une alimentation fiable et des performances audio de haute qualité.
Dimensions : 483 x 44 x 360 (mm) 1U 19 pouces

Amplificateur classe D - 2x 900W sous 4 ohms et 1000W sous 100V

Le SLI1000.2 est un amplificateur de classe D compact et puissant à faible impédance.
Il délivre 2 x 900W sous 4 Ohm.
Il dispose d'un contrôle de volume et d'indicateurs LED pour le signal, le clip et la sécurité, pour un fonctionnement intuitif et sûr.
Les connexions se font via des fiches combo et Speakon, pour une grande polyvalence et une installation facile.
De plus, le SLI1000.2 est équipé d'un filtre et d'un mode 100 V, ce qui le rend idéal pour les applications nécessitant une puissance élevée et des performances audio de haute qualité.
Dimensions : 483 x 44 x 360 (mm) 1U 19 pouces

The ALI20/25 are audio line isolators designed to isolate audio devices from each other. In most cases, they are used to avoid hum caused by ground loops in audio systems. They offer a complete passive solution for the isolation of a stereo balanced audio signal. It features dual XLR in- and output connectors and a ground lift switch. The in- and output phase are matching. The ALI20/25 are both b

-Max. Power: 60 W
-RMS Power: 30 W
-Speaker type: 2-way coaxial
-Drivers: 4"
-Impedance: 16 Ohms
-Connectors: 4-pin Euro Terminal Block
-Sensitivity (1W/1m): 80 dB

- Stunning designed and elegant looking ABS enclosure
- Innovative & unique design
- Wide opening angle
- Multi-tapping 100V line transformer
- AWX5™ waterproof connector
- Outdoor rated construction
- Countless mounting possibilities

- Stunning designed and elegant looking ABS enclosure
- Innovative & unique design
- Wide opening angle
- Multi-tapping 100V line transformer
- AWX5™ waterproof connector
- Outdoor rated construction
- Countless mounting possibilities

-Max. Power: 60 W
-RMS Power: 30 W
-Speaker type: 2-way coaxial
-Drivers: 4"
-Impedance: 16 Ohms
-Connectors: 4-pin Euro Terminal Block
-Sensitivity (1W/1m): 80 dB

-Speaker type: 2-way coaxial
-Max. Power: 120 W
-RMS Power: 60 W
-Impedance: 16 Ohms
-Connectors: 4-pin Euro Terminal Block
-Sensitivity (1W/1m): 83 dB

"Don't feel like hanging around?" \n The ALTI6M is a variant of the ALTI pendant speakers, featuring a die-cast mounting bracket for wall & ceiling mount purposes. This allows the same audio system design and identity throughout the entire installation in case some areas are not allowing pendant solutions being used due to the ceiling heights or structures. Acoustics and construction are id

"Don't feel like hanging around?" \n The ALTI6M is a variant of the ALTI pendant speakers, featuring a die-cast mounting bracket for wall & ceiling mount purposes. This allows the same audio system design and identity throughout the entire installation in case some areas are not allowing pendant solutions being used due to the ceiling heights or structures. Acoustics and construction are id

-Speaker type: 2-way coaxial
-Max. Power: 120 W
-RMS Power: 60 W
-Impedance: 16 Ohms
-Connectors: 4-pin Euro Terminal Block
-Sensitivity (1W/1m): 83 dB

-THD+N (@ 1 kHz): < 0.015%
-Crosstalk (@ 1 kHz): < -98 dB
-Efficiency: > 70%
-Cooling: Convection cooled
-Control: RS-485, TCP/IP
-Power: PoE 802.3bt
-Protection: Over heating, Over load, DC Short circuit, Signal limiting

The ANX44 is a Dante audio network interface for installation in the XMP44 professional modular audio system, featuring four input and four output channels. The installation of this optional module allows the XMP44 to be integrated into any DANTE enabled AV network and flawlessly transfer digital audio with any compatible product on the market. \n The bidirectional audio exchange with the 4 Sourc

The APC100 is a configuration and control unit which can be used in combination with a wide variation of 'smart' AUDAC devices, ranging from matrix systems and mixers to paging consoles and wall panels. It features different types of communication ports, such as TCP/IP, RS-232 & RS-485. This way, it can communicate with every 'smart' device connected in your installation and establish the mis

(4) BASE FOR GOOSENECK MICROPHONE

DIGITAL PAGING MICROPHONE 1 ZONE

DIGITAL PAGING MICROPHONE 4 ZONES

DIGITAL PAGING MICROPHONE 16 ZONES

The ARES5A is a 2-way active speaker system consisting of an active and passive unit to be linked with each other. It offers an easy and flexible solution for a wide variety of applications.The 2-way loudspeaker is carefully constructed out of high quality components resulting in a 5 ¬? woofer and a «? high frequency tweeter. This craftmanship in combination with an integrated DSP is creating an

The ARES5A is a 2-way active speaker system consisting of an active and passive unit to be linked with each other. It offers an easy and flexible solution for a wide variety of applications.The 2-way loudspeaker is carefully constructed out of high quality components resulting in a 5 ¬? woofer and a «? high frequency tweeter. This craftmanship in combination with an integrated DSP is creating an

4 CHANNEL DIGITAL RELAY UNIT - RS485 & TCP/IP - EXTRA LOW VOLTAGE - DPDT - DIN RAIL

8 CHANNEL DIGITAL RELAY UNIT - RS485 & TCP/IP - EXTRA LOW VOLTAGE - DPDT - DIN RAIL

(4) FM/DAB/DAB+ ANTENNA SPLITTER 1IN/4OUT INCL 4xF/F CABLE+CON

The SP series are high-efficiency sound projectors designed to provide good speech intelligibility and background music in a wide variety of applications. Designed for indoor use and perfectly suited to be used in large 70/100V broadcast systems such as train stations or airports. The ASP20 is a 20 Watt spherical loudspeaker, fitted with an 8" driver and a 70/100V line transformer with different

The SP series are high-efficiency sound projectors designed to provide good speech intelligibility and background music in a wide variety of applications. Designed for indoor use and perfectly suited to be used in large 70/100V broadcast systems such as train stations or airports. The ASP20 is a 20 Watt spherical loudspeaker, fitted with an 8" driver and a 70/100V line transformer with different

Peak power handling 40 W
Program power handling 20 W
Speaker type Full range
RMS/AES power handling 10 W
16 Ω
Incline angle Left 25°
Right 25°
Bottom 25°
Top 15°
Sensitivity (1W/1m) 83 dB
Sound Pressure (Max. W/1m) 93 dB
Frequency Response (± 3 dB) 120 Hz - 20 kHz
Range (-10 dB) 100 Hz - 20 kHz
Dispersion Horizontal 145°
Vertical 170°
Ingress Protection rating IP40
Connectors 2-pin Euro Terminal Block
Drivers 2” Aluminium full range