Look Solutions Cryo-Fog Low Pressure 230V (to be used with low pressure tank with 20-24 Bar)
LOO-400
- Procedure: Vaporizing fog machine with CO2 cooling system
- Power requirement: 2300 Watt / 1700 Watt (at 120 V)
- Voltage: 230 V / 50 Hz, 120 V / 60 Hz
- Warm up time: approx. 7 min.
- Fluid consumption: at 100% output 100 ml/min, at 50% output 40 ml/Min.
- Fluid tank capacity: 5 liter
- Fog output: adjustable in 99 steps
- Fogging time: continous output
- Temperature control: Microprocessor controlled
- Overheating protection: Heater block/thermostat, Pump/Thermal switch
- Control: DMX 512, 0 – 10 V analog
Tijdelijk niet op voorraad
The Cryo-Fog LP is a powerful 1700 Watt low fog generator with fogger and cooling chamber all built in to a road case that’s only 26″ x 20″ and 12″ tall! It uses Cryo-Fog Fluid to make dense white fog and requires a low pressure dewar tank of liquid CO2 (available from any gas company) to chill the fog and cause it to lay low. It can be controlled with 3 channels of DMX – 1 for fog output, 1 for temperature, and 1 for fan – and each parameter can be variably adjusted from 1-100%. This allows you to create thin fog that creeps across the floor, billowing clouds that look like ocean waves, or anything in between. It comes with 5L of Cryo-Fog Fluid and a 5m hose for connecting a dewar of CO2. Low pressure dewar tanks hold an average of 400 lbs of liquid CO2 and are recommend when need a lot of low fog, for a permanent installation or long running show. For short and/or portable productions, the CryoFog HP is recommended instead, as high pressure tanks are much smaller, and the ease of use outweighs the higher cost per lb. of CO2.