2 channels, 260 watts/ch at 8ohm, 425 watts/ch at 4ohm, 700 watts/ch at 2ohm.

Media Drive Kit for Core 110f ONLY - Provides a minimum of 200 hours of audio storage (WAV, MP3 or FLAC)

26-port network switch preconfigured for Q-SYS Audio, Video and Control with 24x PoE+ ports and 300 Watts PoE budget. Features advanced QoS and IGMP configuration to also support AES67 and Dante within the same VLAN.

Video I/O
HDMI 2.0 inputs: 1x HDMI 2.0, capable of receiving input video formats up to 4K60 4:4:4
USB-C Input: 1x USB 3.2 Gen 1x1 (5Gbps) Type-C Device Port
- Supporting DisplayPort Alt-Mode (DP 1.4 Sink)
- capable of receiving input video formats up to 4K60 4:4:4
HDMI 2.0 Output: 1x HDMI capable of scaling and outputting video formats up to 4K60 4:4:4
Scaler: HDMI output features a robust 4K60 4:4:4 scaler that can accomodate the most challenging resolution and frame rate conversions.

Audio I/O
HDMI inputs: 8-channel PCM audio, Q-SYS routable
USB Type C input: 8-channel PCM audio, 1x1 speakerphone1, 2x2 soundcard1, Q-SYS routable
HDMI outputs: 8-channel PCM audio, Q-SYS routable

The NV-32-H (Core Capable) is a multipurpose, software-configurable video endpoint driven by the Q-SYS OS, offering two distinct operating modes to choose between, based on the needs of the application. ‘Core Mode’ transforms the device into a fully integrated Q-SYS processor with local HDMI switching capabilities. ‘Peripheral Mode’ allows multi-stream video encoding or decoding for network-based HDMI video distribution. Like all Q-SYS devices, the NV-32-H (Core Capable) offers native integration and control driven by the Q-SYS OS, simplifying setup and configuration while eliminating the need for advanced programming knowledge

Q-Sys gooseneck page station podium mounting flange accessory.

Page station extender. Connects directly to the rear of an Q-Sys page stations and is designed to be mounted on the wall.

Pilot tone load for end of line monitoring.

Accessory Ceiling Mount Bracket for PTZ Camera Available April 2017

SYSTEM REQUIREMENTS: In order to deploy Software-based Dante, your Q-SYS designs must be installed with Q-SYS Designer Software v8.3.1 or higher.

Availability on other Q-SYS Core models will come in the future