Celto Acoustique C2.10 - 2X 1100W amplifier
CTO-C210
- Robust amplifier
- 2x 1100W 4 Ohm (2x 750W 8 Ohm) max power
- Linear toroidal transformer with aluminum
- Low distortion peak limiter
- Class H output stage
- Protection: Soft Start, Short Circuit, Over Voltage, Over Current, Overload, DC Output, Temperature
- 15 kg weight
From 8 St to 765,37 € (5% discount) Temporarily out of stock
Max output Power EIA 1kHz 1% THD (EIA = 33ms ON / 66ms OFF): 2x 750W 8 ohms | 2x 1100W 4 ohms | 1x 2200W 8 ohms (Bridge)
Overall gain: 35dB (50 times voltage)
Sensitivity at 8 ohms: >108dB
Frequency Response (-1dB): 20~20000Hz
Typical THD (half power, 1kHz, 8 ohms): <0.1%
Typical IMD (1kHz at 4:1, -20dB): <0.3%
Crosstalk (1kHz): >65dB
Slew Rate: >20V/us
Input Impedance: 20 kΩ
Damping factor (1kHz, 8 ohms): >500
Protections: Soft-Start, Short-Circuit, Over-Voltage, Over-Current, Over-Load, DC Output, Temperature
Operating Voltage: 190~260VAC 50-60Hz
Preamp: Low noise and low distortion circuit, PeakStop Opto-Limiter
Power Supply (PSU): Linear topology with toroidal transforner
Output stage: 2-step Class H without cross-rail distortion (70% efficiency)
Cooling: Front to back airflow, Temperature regulated fans, Copper heat-sink for maximum heat transfer
Rear Panel: 2 NEUTRIK XLR Input with latch, 2 NEUTRIK XLR Link ,2 NEUTRIK Speakon NL4, 2 speaker Binding post terminals, Stereo / Parallel / Bridge switch, Ground / Lift switch, Magnetic Breaker, PowerCon 20A (Included)
Speakon Wiring: SPK1 = 1+1- CH A / 2+2- CH B | SPK2 = 1+1- CH B / 2+2- Not Used
Chassis: 19" 2U height, 378mm total depth
Weight Net / Gross: 16kg /